Audio Technica VM95E/H Cartridge Package

$169.00

Elliptical diamond stylus and dual magnet setup

SKU: AT_VM95EH Category:

This Package Includes:

  • 1 x Audio Technica AT-VM95E Cartridge
  • 1 x Audio Technica AT-HS6 Headshell

This VM95 Series cartridge with 0.3 x 0.7 mil elliptical stylus fits half-inch mount turntables. The cartridge’s special coil design delivers a powerful output level of 4.0 mV. It also offers excellent channel separation and low distortion for outstanding tonal quality. The durable, low-resonance housing includes threaded inserts that enable the cartridge to be mounted to the headshell with just two screws, no nuts required. And since all VM95 Series share the same body, the stylus can be replaced with any of the six interchangeable AT-VMN95 replacement styli.

The AT-VM95E

The AT-VM95E will replace the legendary AT95E and take advantage of the developments of the AT95EX introduced in 2015. The AT-VM95E features an improved and distinctive design resulting in a more rigid low resonance housing, and two threaded inserts in the cartridge body enabling it to be mounted to the headshell or on an integral tonearm with just two screws, no nuts.

Elliptical Bonded Stylus

Elliptical diamond stylus follows the groove modulation with greater precision compared to a conical stylus, offering improved frequency and phase responses whilst reducing distortion.

Features…

  • VM dual magnet cartridge with 0.3 x 0.7 mil elliptical stylus
  • AT-VM95E mounted on AT-HS6BK headshell
  • The total set weight is 15.5g
  • Assembled and tested in the Audio-Technica Factory in Fukui-Japan
  • Quick and easy installation
  • 20 to 22,000Hz frequency response

Specifications…

  • Frequency Response: 20-22,000 Hz
  • Channel Separation: 20 (dB at 1 kHz)
  • Vertical Tracking Angle: 23°
  • Vertical Tracking Force: 1.8-2.2 g (2.0 g standard)
  • Stylus Construction: Bonded round shank
  • Recommended Load Impedance: 47,000 ohms
  • DC Resistance: 485 ohms
  • Output: 4.0 mV (1 kHz, 5 cm/sec.)
  • Stylus Shape: 0.3 x 0.7 mil elliptical
  • Weight: 6.1 g
  • Dimensions (H x W x D): 17.2 × 18.9 × 28.3 mm

Audio Technica’s AT-HS6

The AT-HS6 is a universal ½”-mount headshell for 4-pin turntable cartridges. It features an ultra-lightweight (9 g) aluminum die-cast body to keep vibration to a minimum and a finger lift to enable precise stylus placement. The headshell is also equipped with gold-plated lead wires for lossless signal transmission and comes with mounting screws.

Specifications…

  • Universal ½”-mount headshell for 4-pin turntable cartridges
  • Ultra-lightweight aluminum die-cast body keeps vibration to the bare minimum
  • Finger lift for precise stylus placement
  • Gold-plated lead wires for lossless signal transmission

Read up on some reviews here – Hifi Choice Mag / Top New Review

Brand

Scroll to Top